VAP fails to connect.

2 posts / 0 new
Last post
riosra
riosra's picture
VAP fails to connect.

Netgear R8000

DD-WRT Firmware: DD-WRT v3.0-r29440M kongac (04/24/16)

 

Hi everyone,

Trying to set up a VAP and while I can see the SSID, I still can't connect to it.  Followed the instructions here http://www.ciscopress.com/articles/article.asp?p=1730493 and here  https://www.dd-wrt.com/wiki/index.php/Guest_WiFi_%2B_abuse_control_for_b...

My settings are in the screenshots below.  

Please disregard the DNS targets, I was just changing IPs around

Any help would be appreciated!

 

riosra
riosra's picture
Syslog shows the following:

Syslog shows the following:

(a) why are the time stamps off? Nettime server is running and configured properly?

(b) this may explain why I can't connect.  Anyone know whats causing this?

Jan 1 00:00:05 BULAKLAK daemon.info mstpd: set_br_up: br2 was up
Jan 1 00:00:05 BULAKLAK daemon.info mstpd: set_br_up: Set bridge br2 up
Jan 1 00:00:05 BULAKLAK daemon.info mstpd: set_if_up: Port wl1.1 : up
Jan 1 00:00:05 BULAKLAK daemon.info mstpd: error, ethtool_get_speed_duplex: Cannot get speed/duplex for wl1.1: Not supported
Jan 1 00:00:05 BULAKLAK daemon.info mstpd: set_br_up: br2 was up
Jan 1 00:00:05 BULAKLAK daemon.info mstpd: set_br_up: Set bridge br2 up
Jan 1 00:00:05 BULAKLAK daemon.info mstpd: set_if_up: Port wl1.1 : up
Jan 1 00:00:05 BULAKLAK daemon.info mstpd: error, ethtool_get_speed_duplex: Cannot get speed/duplex for wl1.1: Not supported