New R8500 router upgraded to the 14 November 2016 release of Kong firmware. Router configured and restarted several times. Router was set to auto restart at 6;00 am everyday. Next day no wireless radio so I checked the radio and only the power light is white and antennas lights are on. I tried to connect to the router via cable no luck, no ping, no response. I have tried the 30/30 reset and nothing. The router seems to do a regular boot sequence but goes dead. Fyi I had increased the TX power rate to 213 from 71. That's it. Any advise would be greatly appreciated
You are here
Back to TopMyOpenRouter.com is not affiliated with NETGEAR®. NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or other countries. Other brand names mentioned herein are for identification purposes only and may be trademarks of their respective holder(s). © 2020 All rights reserved.
Contact Netgear support, that could be the BOOT LOOP issue. But don't tell them U have already change firmware to DD-WRT
Is your router back up and now try pressing reset button after u power on the router for 5 seconds